Stainless steel mesh with the tightness of the chain should be how to master

Stainless steel wire mesh with a variety of chain type stainless steel mesh belt is used in the daily life of a kind of more extensive, other herringbone stainless steel mesh belt, stainless steel mesh belt, eyes stainless steel mesh belt, etc according to the actual requirements to add the chain, and the role of the chain is to transport in the process of running deviation phenomenon will not occur. So, how should the tightness of the chain of stainless steel mesh belt be mastered?

We can use scheduling spanner each time to have 90 degrees of cragging scheduling; It is ok to adjust to the appropriate tightness, which can adhere to a good consistency. What we need to pay attention to is that in the adjustment, we should remember to appropriately loose some of the best.

Because, when tightening the rear axle bolt, it will be further tighter than when loosening it! In addition, assuming that the stainless steel chain is a little too tight, it is ok to loosen the same Angle of the bolts at both ends with a wrench, and the best is to step up to 90 degrees, after loosening the bolts, and try to see if the tightness of the stainless steel chain is almost the same.

Stainless steel mesh belt chain tightness of the primary scheduling method is these, we must according to the description of reasonable adjustment, as long as so ability to make its function is fully displayed, bring us higher efficiency of operation.