how to use mesh conveyors

Before the operation of the net belt conveyor, it is necessary to confirm that the equipment, personnel and transported items of the net belt conveyor are in a safe and sound state; Secondly, check the normal movement of the parts, check whether all the electrical lines are normal, normal can be put into operation belt conveyor. Finally, check that the difference between the supply voltage and the rated voltage of the equipment is no more than ±5%. The specific operation of the net belt conveyor is as follows:

1. Close the general power switch and check whether the power supply of the equipment is normally fed and whether the power indicator is on. Go to the next step.

2. Switch on the power switches of each circuit to check whether the circuit is normal. In the normal state, the equipment does not work, the operation indicator light of the net belt conveyor is not on, the power indicator light of the inverter and other equipment is on, and the display panel of the inverter is normal.

3. Start each electrical device in turn according to the process flow. Start the next electrical device after the previous one starts normally.

4. In the operation of the net belt conveyor, it is necessary to comply with the provisions of the design of the goods to be transported, and comply with the transport capacity of the net belt conveyor. Secondly, we should pay attention to all kinds of personnel shall not touch the moving part of the net belt conveyor, and non-professionals shall not contact electrical components and control buttons at will. Finally, in the operation of the net belt conveyor, the frequency converter can not be disconnected. If the maintenance needs are determined, it must be carried out under the condition of stopping the frequency conversion operation, otherwise the frequency converter may be damaged.

5. When the net belt conveyor stops running, press the stop button to cut off the total power supply until the system stops completely.