Analysis of reasons for broken wire of stainless steel mesh belt

1. Improper adjustment of the head size will lead to disorder of the normal compression ratio, resulting in wire breakage in the weaving process. The solution is to ensure the absolute size of the die on the machine.

2. Oil or water is cut off in the process of mold operation, resulting in short operation with large hole spacing and unbalanced compression ratio, thus breaking the line. The solution was to add lubricant to each mould in time to ensure cooling and lubrication.

3, in the weaving process, when wicker lines appear, fast winding will lead to broken stainless steel wire. The only solution is to change the mold to ensure this phenomenon does not happen again.

4. Excessive consumption of natural roads in the mold leads to the imbalance of compression ratio before and after knitting and the appearance of broken wires, which is mainly reflected in several broken wires in one position. The solution is to change the mold, adjust the compression ratio before and after, until normal.